CAMBRIDGE QT Guia de Instalação descarregar pdf (Página 22)

page 22

System Control Using Monitor Control Software (MCS)

The MCS (Monitor Control Software) is an interface that congures

the QtPro over a LAN/network connection. The MCS software is

operated from any network browser. Below are the instructions to

connect to the control module over Ethernet locally and over the

network.

After the discussion on connecting to the control module, the MCS

screens will be discussed.

Connecting to the Qt 300/600 over Ethernet

1. System software is operated from any network browser. Software

is pre-installed in the control module. The HELP function

provides comprehensive software control operating instructions.

2. Connect a computer or the network to the 10/100 Ethernet jack.

3. Power the control module on by plugging it into a standard wall

outlet.

4. Press the right arrow on the control module to advance to the IP

address screen. An assigned IP address is displayed on the front

panel within two minutes of powering the module.

5. Access the Qt System Monitoring and Control Software

a. Read the control module Hostname or IP address

from the front control panel.

b. Enter either the hostname or IP address into the

browser address bar.

c. A prompt will appear requiring a username and

password.

d. The default username is “admin”. The default

password is “secret”.

6. After logging in with the defaults, you may change the

hostname, username and password.

DHCP Support

The system uses DHCP to obtain an IP address.

The system displays its MAC address on the front panel. This allows

the network administrator to use the MAC address to congure

the DHCP server to deliver a xed (static) IP address to the control

module.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Sem comentários

CAMBRIDGE QT Guia de Instalação Página 22